New Heat Pump Systems Sized to the House
Heat Pump Installation in collins and the surrounding areas for homes replacing aging equipment or converting from a different heating source
RSK Heating & Air starts each heat pump installation by looking at the specific needs of the home instead of simply matching the size of the old equipment. For homes in Collins and the surrounding areas, the team reviews the home’s heat load, existing ductwork, and attic or crawl space conditions before recommending a system.
The indoor and outdoor components are then matched and installed together to help support consistent performance, airflow, and comfort throughout the home. By considering the duct system and overall layout from the beginning, RSK can recommend equipment that is better suited to the home rather than relying on a one-size-fits-all replacement.
What Proper Heat Pump Installation Requires
Installation begins with removing the old outdoor condenser and indoor coil, then setting the new equipment in position and making the refrigerant line connections. RSK pressure-tests those connections before charging the system, which confirms there are no leaks in the line set before refrigerant is introduced. The charge is set to the manufacturer's specification for the actual installation conditions, not a standard factory charge, and the system is tested in both heating and cooling modes before the thermostat is programmed for the homeowner.
Once the installation is complete, the homeowner should notice consistent supply air temperature at every register, and the system should reach setpoint within a reasonable runtime without the auxiliary heat strip activating at moderate outdoor temperatures. The thermostat programming is completed as part of the installation, so the schedule and mode settings reflect how the household actually uses the home rather than factory defaults.
RSK Heating & Air is family-owned and EPA certified, and the refrigerant work is handled by the same crew that sizes and installs the system, not a separate sub. If the existing ductwork has leaks or undersized runs that would compromise the new system's performance, that is identified during the pre-installation measurement and can be addressed before the new equipment is set.

Answers About How the Work Is Done
The questions below explain what happens during a heat pump installation, from the load calculation through the final system test.
What does a heat load calculation involve and why does it matter here?
The calculation accounts for the home's square footage, ceiling height, insulation levels, window area, and duct condition to determine how much heating and cooling capacity the house actually requires. In older Savannah-area homes with inconsistent insulation, the calculated load frequently differs from what the original equipment provided, so the calculation prevents repeating the original sizing error.
How are the indoor and outdoor components matched during installation?
RSK selects indoor and outdoor units from the same system family so the coil, refrigerant charge, and control logic are designed to work together. Mismatched components can prevent the system from achieving its rated efficiency and may cause the defrost cycle to operate incorrectly in heating mode.
Why is pressure-testing the refrigerant lines done before charging the system?
Introducing refrigerant into a line set that has a leak results in a system that loses charge slowly, operates below capacity, and eventually causes compressor damage from running in a low-charge condition. Pressure testing with nitrogen before the charge is added confirms the connections are sealed under the operating pressure the lines will carry.
What is included in the final system test before the installation is closed?
RSK runs the system in both heating and cooling modes, checks supply air temperature at the registers, verifies the outdoor unit cycles correctly through its defrost routine, confirms the refrigerant charge against manufacturer specifications, and programs the thermostat before the crew leaves the property.
How does the existing duct condition affect a new heat pump installation?
A duct system with significant leakage or undersized branch runs will prevent a correctly sized outdoor and indoor unit from delivering its rated performance. RSK measures duct capacity during the pre-installation assessment so any ductwork issues are identified before the new equipment is set rather than discovered after the system is running.
RSK Heating & Air also installs heat pump systems in Vidalia, collins, Lyons, Reidsville, and beyond. To begin with a load calculation and duct assessment for your home, call RSK Heating & Air at (912)6064855 and set up an on-site visit before any equipment decision is made.